Sony DVS-9000SF User Manual page 449

Icon Title Message
Activate The license key you entered is
License invalid.
Please check and enter again.
Activate License key was successfully
License entered.
The license will be activated
after rebooting your system.
Deactivate The license will be deactivated
License after rebooting your system.
Disk Success!!
Format
Failure.
Make sure of the memory card.
Error This operation is cancelled,
because the register is locked.
Please change the register
status to be unlocked first.
Failed...
File Open ERROR (01)
Status
ERROR (02)
ERROR (FF): No target device
has been assigned
Description
7316.7: Engineering Setup>System>Install/Unit
Config>License>License Management
In the above menu, since the entered
information was incorrect, the Activate License
procedure failed. Check the license key, and
enter again.
7316.7: Engineering Setup>System>Install/Unit
Config>License>License Management
In the above menu, the Activate License
procedure completed successfully.
7316.7: Engineering Setup>System>Install/Unit
Config>License>License Management
In the above menu, the Deactivate License
procedure completed successfully.
7317: Engineering Setup>System>
Maintenance
In the above menu, removable disk formatting
procedure completed successfully.
7317: Engineering Setup>System>
Maintenance
In the above menu, removable disk formatting
procedure failed. Check that the memory card
is correctly inserted.
6211.1: Effect>Master Timeline>Store>Edit
6311.1: Snapshot>Master Snapshot>Store>
Edit
6411.1: Shotbox>Register>Store/Recall>Edit
In the above menu, an attempt was made to
assign to a register that is locked. Unlock the
register before carrying out the assignment.
7162: File>All, External File>Import/Export
In the above menu, importing a file failed.
Check the format of the original file, and try
again.
533X: Device>DDR/VTR menu
When an error is returned from the DDR/VTR,
one of these messages appears, depending on
the error number.
Use menu 7355: Engineering Setup>DCU>
Serial Port Assign or menu 7325.4:
Engineering Setup>Panel>Device Interface>
Serial Port Assign to check the device settings.
449
Error Messages