Sony DVS-9000SF User Manual page 102

2
3
4
5
102
DME Special Effect Operations
Press [Spot Lighting], turning it on.
This enables Spotlighting, and you can now use the knobs to adjust the
parameters.
Set the following parameters.
Knob Parameter
1 Total Ambient Brightness of whole image
• Lowering the brightness of the image makes Spotlighting more
effective.
• The Total Ambient setting is shared with the Lighting function.
In the <Surface Select> group, select the state of the surface struck by the
light.
Flat: The image surface is unchanged, causing the selected light source to
appear as the effect.
Texture: A texture appears on the surface of the image.
Non Linear: The Spotlighting effect is applied to an area to which a DME
nonlinear effect is applied.
Notes
• The BZS-9471 Texture Lighting Software (for BKDS-9470) or BZDM-
9050 Texture Lighting Software (for MVE-9000) is required to enable
Texture or Non Linear.
An install key must be entered to use the software (see page 241).
• The Spotlighting Non Linear effect is not effective for the following
nonlinear effects. The result is the same as choosing Flat.
Swirl, Multi Mirror, Character Trail, Kaleidoscope, Slide, Sphere,
Twist, Circle, Explosion, Melt, Mirror, Split, Broken Glass, Flying
Bar, Cylinder, Rings
If you selected Texture or Non Linear in step 4, set the following
parameters.
Parameters when you selected Texture
Knob Parameter Adjustment
1 X Movement in X-axis direction
2 Y Movement in Y-axis direction
3 Size X Image size in X-axis direction
4 Size Y Image size in Y-axis direction
5 Amp Emphasize bumps and
depressions
Adjustment Setting values
0.00 to 100.00
Setting values
a)
–8.00 to +8.00
b)
–6.00 to +6.00
0.50 to 16.00
0.50 to 16.00
c)
–100.00 to +100.00