Selecting The State After Powering On (Start Up Menu) - Sony DVS-9000SF User Manual

2
Press [Active Line/Aspect].
The Active Line/Aspect menu appears.
The status area shows the number of active scan lines and screen aspect
ratio for the switcher and connected DME(s).
3
In the <Active Line> group, select the number of active scan lines.
Setting the screen aspect ratio
Use the following procedure.
1
In the System>Format>Active Line/Aspect menu, select one of the
following from the <Screen Aspect> group.
• 16:9
• 4:3
• Independ: Set the screen aspect ratio separately for M/E, P/P, and USER
on the switcher, and for each channel independently on the DME.
2
If you selected [Independ] in step 1, select from the following.
Switcher Aspect: Make the setting for the switcher.
DME Aspect: Make the setting for the DME.
A menu appears according to the selection.
3
Carry out either of the following, depending on the selection you made in
step 2.
When you selected [Switcher Aspect]: In each of the <M/E-1>, <M/E-
2>, <M/E-3>, <P/P>, and <USER> groups, select either [16:9] or
[4:3].
When you selected [DME Aspect]: For each of the <CH1> to <CH4>
groups, select either [16:9] or [4:3].

Selecting the State After Powering On (Start Up Menu)

To set the initial state at start-up, use the System>Start Up menu.
Note
It is not possible to set the DCU state at start-up, but its settings can be saved
in the control panel.
Setup for the Whole System
237