Sony DVS-9000SF User Manual page 139

2. Press the [REWIND] button.
3. Press the [RUN] button.
Making and saving settings relating to Cueup & Play
Use the following procedure.
1
Press the [EFF] button in the numeric keypad control block, turning it on.
This assigns the numeric keypad control block to keyframe operations, and
the [RCALL] button lights.
2
Press the region selection button for the region for which you want to make
the setting, turning it on.
You can select more than one button.
3
Enter the number of the register to be recalled with the numeric keypad
buttons.
To search for an empty register, instead of entering a number, press the [.]
(period) button.
The display shows the register number. A letter "e" or "E" after the number
indicates the register status, as follows:
e: This register is empty in the selected region.
E: This register is empty in all selectable regions.
4
Press the [ENTER] button.
This recalls the register you selected in step 3.
5
Press the [DEV] button in the device control block, turning it on.
Note
Check that the [MENU] button is not lit. If it is lit, press to turn it off.
6
With the device selection buttons in the device control block, select the
VTR or disk recorder for which you want to make the setting.
You can select more than one button.
The first button pressed lights green to indicate the reference region, and
the subsequent buttons light amber.
7
To set the start point, play back on the VTR or disk recorder by control
from the device control block. Find the desired start point, and at that point
Control of VTRs and Disk Recorders
139