Sony DVS-9000SF User Manual page 132

4
5
Repeat steps 1 to 5 for other GPI output ports as required.
Testing trigger output
To test the trigger output, press [Test Fire].
According to the list settings on the left of the status area, a pulse is output from
the selected output port.
Clearing output port settings
To clear the settings for each device (GPI output port)
Use the following procedure.
1
132
Control of GPI Devices
Knob Parameter
2 GPI Port No
a) 1: Off (no specification)
2: Control panel (SCU) GPI port
3: DCU GPI port
If in step 3 you selected 2 (SCU) or 3 (DCU), then use the knob to select
the port number.
The indication for knob 3 depends on whether SCU or DCU is selected.
Knob Parameter
3 SCU Port No
3 DCU Port No
a) The number of DCU GPI ports depends on the settings in Engineering Setup.
The setting is reflected in the list on the right of the status area.
Press [Set].
This specifies the SCU/DCU GPI port whose number you specified in step
4 as the pulse output destination for the GPI output port selected in the list
on the left of the status area.
In the list on the left of the status area, select the GPI output port whose
settings you want to clear.
Setting
SCU/DCU GPI port to be the
trigger output destination
Setting
SCU GPI port number
DCU GPI port number
Setting values
a)
1 to 3
Setting values
1 to 8
a)
1 to 50