Sony DVS-9000SF User Manual page 265

Knob Parameter
1 Source No
2 No
• For a button whose operation you want to disable, press [Inhibit].
5
Press [Source Set] to confirm the selection.
To set the shift operation of the source selection buttons
To set the operation mode of the rightmost button in the source selection button
row with different destinations assigned to the 1st and 2nd rows, select the
source table in the Source Table Assign menu, then in the <Xpt Shift Mode>
group select one of the following.
Hold: Acts as a shift button, and the shifted source selection buttons are
effective while the button is held down.
Lock: Acts as a shift button, and pressing the button toggles between the
shifted and unshifted states of the source selection buttons.
Off: Acts as a cross-point button, that is, button number 16 on a 16-button
system, button number 24 on a 24-button system, and button number 32 on
a 32-button system.
To expand the shift function
To set the [KEY] button as a shift operation expansion button, in the Source
Table Assign menu select the source table, then in the <Expand Xpt Shift
Assign> group, press [KEY Button].
In order not to expand the shift operation, press [No Assign] in the <Expand
Xpt Shift Assign> group.
To assign levels to a level selection button
To assign levels to the [LEVEL1] to [LEVEL4] buttons in the auxiliary bus
control block, use the following procedure.
1
In the RTR Mode Setting menu, press [Level Button Assign].
The Level Button Assign menu appears. The status area shows a list of the
assignment status of levels to each button.
2
In the <Level Button Select> group, select the button you want to set.
3
In the <Level Assign> group, press the levels you want to assign to the
button, turning them on.
You can select plural of levels. You can also make a selection that overlaps
that of another button.
Adjustment
Source selection button selection
Source selection in S-Bus space
Setup Relating to Operations From the Control Panel
Setting values
1 to 128
1 to 1024
265