Sony DVS-9000SF User Manual page 300

For more details, see "Flip-flop mode and bus fixed mode" in Chapter 1
(Volume 1).
Setting the split fader to be enabled or disabled
In the Transition menu, press [Split Fader] to switch between Enable and
Disable. This setting is only valid when using a simple transition module with
Bus Toggle set to Off.
Note
This setting is disabled for the CCP-9000.
Enable: When the fader lever is split, the split fader effect is enabled.
Disable: Even when the fader lever is split, the normal fader lever effect is
Enabling or disabling the fade-to-black function
In the <FTB> group of the Transition menu, press the program output name to
toggle between On and Off.
Note
This setting is disabled for the CCP-9000.
On: When the [FTB] button is pressed, a fade-to-black is carried out.
Off: Even when the [FTB] button is pressed, no fade-to-black is carried out.
Note
The PGM2 to PGM4 settings are only valid in Multi Program mode or DSK
mode.
Setting a preset color mix
Use the following procedure.
1
2
300
Setup Relating to Switcher Processor
obtained.
In the Switcher>Transition menu, press [Preset Color Mix].
The Preset Color Mix menu appears.
The status area shows the stroke mode setting for each M/E bank, the
setting for whether or not the key status is maintained, and the one-time
mode setting.
In the <Stroke Mode> group, select whether to carry out a transition in one
stroke or two strokes.
Normal: Carry out a preset color mix with two transition operations.