Selecting The State After Powering On (Start Up Menu) - Sony MVS-8000X System User Manual

Multi format switcher system

Hide thumbs Also See for MVS-8000X System:

Table of Contents

Selecting the State After Powering On (Start

Set the initial state of the devices when the system is powered on.

For each device, you can select Resume mode or Custom mode.

This resumes the setting state at the previous power-off operation. This setting

is only available for the switcher processor and control panel.

This uses the settings saved in non-volatile memory or ROM within the device.

In this mode, there are Setup and Initial Status settings which can be set

• Setup mode: Select the setup state to be used after powering on from the

• Initial status mode: Select the state of each device after powering on

(excluding the settings to which "setup" applies).

For details of saving and recalling setup data, see "Saving and Recalling Setup

Data" (page 915) and the appendix "Data Saved by [Setup Define] and [Initial

Status Define]" (page 1126).

Autoload function

Switch on or off the function to automatically load predetermined register data

or frame memory image data at power on. Set the data to be read in the File

Selecting the State After Powering On (Start Up Menu)

User: Start up using the user data previously saved with [Setup Define].

Factory: Start up with the factory default settings.

User: Start up using the user data previously saved with [Initial Status

Define]. For the control panel, this applies to the key bus delegation

buttons only.

Factory: Start up with the factory default settings.