Before Operating - Omron NT30 Operation Manual

Before Operating

1-5

Before Operating

Caution
Reference
Use the procedure given below to start the NT30/30C.
PC
Check and change
the PC settings.
S For the Host Link, refer
to page 27 (RS-232C),
page 40 (RS-422A)
and the manuals for
the Host Link Unit and
Programming Devices.
S For the NT Link,
refer to page 56.
Connect to the
NT30/30C.
Create the PC
program.
Start operation.
Be sure to confirm that correct operation is possible with the screen data and the
host program before actual operation.
1. Use the System Installer provided with the NT-series Support Tool for Win-
dows.
2. Use the NT-series Support Tool for Windows.
NT30/30C
Set the DIP switch.
(page 18)
Install to the opera-
tion panel.
(page 19)
Connect the power
supply.
(page 20)
Connect to the PC.
S (Host Link:
page 25 (RS-232C)
page 42 (RS-422A))
S (NT Link: page 56)
Check the settings
and communications.
Transfer the
screen data.
(page 89)
Section 1-5
NT-series Support Tool
Install NT-series
Support Tool on the
computer.
(Refer to the manuals
for the NT-series
Support Tool.)
Create the screens.
(Refer to Section 4 and
the manuals for the
NT-series Support Tool.)
13