Initialization Of The Memory Tables - Omron NT30 Operation Manual

Initializing Memory
Reference

3-4-2 Initialization of the Memory Tables

Reference
S The NT30/30C DIP switch SW2 pin 4 is used to enable/disable the screen data
forced initialization. Setting this to ON selects enable initialization, and OFF to
disable it.
S Regardless of whether initialization is executed or not, on completion of the
operation, switch DIP switch SW2 pin 4 OFF while the power to the NT30/30C
is OFF, then start up the NT30/30C again.
It is possible to initialize the numeral memory table and character string memory
table in the NT30/30C. When these tables are initialized, the values are returned
to those set by the NT-series Support Tool.
When memory table initialization is executed in the maintenance mode, the
memory tables are initialized regardless of the resume function setting (see page
96).
If OFF is set for the Resume Function memory switch, the memory tables can be
initialized just by switching the NT30/30C power OFF and back ON again, or by
resetting it (see page 96).
Using the System Menu, initialize the memory tables by following the procedure
given below.
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
[ MAINTENANCE MENU ]
Quit
Display History
I/O Check
PT Settings
Init. Memory
[ INITIALIZE MEMORY MENU ]
Quit
Screen Memory
Memory Table
History Data
Select "Maintenance Mode."
Select "Init. Memory."
Memory Switch
Select "Memory Table."
Section 3-4
81