Before Operating - Omron NT20S-ST121B-EV3 User Manual

Before Operating

1-6

Before Operating

14
Follow the procedure given below to start the system of the NT20.
Host
Set the host settings.
• For the Host Link, refer
to page 44, and the man-
uals for the Host Link
Unit and Programming
Device.
• For a 1:1 NT Link, refer
to page 56.
• For 1:N NT Links, refer to
page 60.
• For high-speed 1:N NT
Links, refer to page 65.
• When using C200H
direct communications,
no settings are required.
• For RS-232C, refer to
page 79 and the manu-
als for the Host.
Connect to the NT20.
Create the host program.
Start operation.
Note System program installation is only done in special circumstances, for exam-
ple when changing the system program, or when recovering the original sta-
tus of the installed program. This operation is not normally necessary.
NT20
Set the DIP switch pins.
(page 19)
Install the PT in the
operation panel.
(page 22)
Connect the power supply
and peripheral device.
(page 23)
Install the system program.
(See note.)
(Refer to page 126 and the NT
Support Tool operation manual.)
Transmit the screen data.
Set the memory switches.
(page 91)
Connect to the host.
Confirm the settings and
check communications.
Section 1-6
NT Support Tool
Install the NT Support
Tool in the computer.
(Refer to the NT Support Tool
Operation Manual.)
Create the screens.
(Refer to the NT Support Tool
Operation Manual.)
(page 102)