Operation Modes And The System Menu; Changing The System Settings; System Menu And The Operation Modes - Omron NT30 Operation Manual

Operation Modes and the System Menu

3-2-1 Changing the System Settings

Procedure 1. Turn ON the power to the NT30/30C.
3-3

Operation Modes and the System Menu

3-3-1 System Menu and the Operation Modes

Power ON
Follow the procedure below to change the system settings or screen data con-
tents.
The NT30/30C will enter the RUN mode and the start-up screen will be dis-
played. The start-up screen varies according to registered screen data.
2. Press touch appropriate switches to display the System Menu, and change
system settings. For the method for calling the System Menu, refer to the
Operations with the System Menu (page 77).
If there is no system program installed, or it is corrupted, it must be installed (or
re-installed). For details on the system program installation method, refer to 2-4
Installing the System Program (page 22).
If the NT30/30C has failed to start up normally; an error message is displayed or
no screen is displayed, memory needs to be initialized.
For the memory initializing procedure, refer to 3-4 Initializing Memory (page 78).
The NT30/30C operates in either RUN, Transmit, or Maintenance mode. The
operation modes can be switched by using the System Menu.
Select an operation mode by pressing the corresponding touch switch in the Sys-
tem Menu. The operation modes with respect to the System Menu are related to
each other as shown below.
For the operations with the System Menu, refer to the Operations with the Sys-
tem Menu (page 77).
RUN Mode
The NT30/30C runs in
this state. Controls from
the PC are enabled and
various indications and
I/O operations are
made.
To change
system settings
or screen data
When system settings
contents
and screen data
registration have been
completed
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance
Mode
Section 3-3
Transmit Mode
Screen data and other
data are transmitted
between the NT30/30C
and the NT-series
Support Tool.
Maintenance Mode
The NT30/30C
maintenance operations
such as memory
initialize and setting
check are executed.
75