Omron NT30 Operation Manual page 47

Connection to a PC by Host Link via RS-232C
DIP Switch Setting for CPM2C
With the CPM2C, in order that the PC Setup settings (data memory) are
enabled, set the DIP switches on the front panel in the way described below.
If (1) the PT is connected to the peripheral port or (2) the PT is connected to the
RS-232C port and a device that requires communications settings other than
the standard settings is connected to the peripheral port, set the DIP switches in
the way shown below.
Set the DIP switches according to the way the peripheral
port and the RS-232C port are used.
• If (1) the PT is connected to the peripheral port or (2) the PT is connected to
the RS-232C port and a device that requires communications settings other
than the standard settings is connected to the peripheral port, set the DIP
switches in the way shown below.
• If the PT is connected to the RS-232C port and a Programming Console is
connected to the peripheral port, set the DIP switches in the way shown
below.
Switch Setting for the RS-232C Adapter
When using the CPM1-CIF01 RS-232C Adapter, set the mode setting switch in
the way shown below.
S Set the mode setting switch to
host (upper position).
S CS1-series CPU Unit: CS1H/G-CPUjj(-V1)
Connect to the CPU Unit's RS-232C port or the RS-232C port of the Communica-
tions Board. When connecting to the peripheral port, use the CS1W-CN118 Con-
necting Cable.
PC Setup Settings
When connecting to a CS1-series CPU Unit, make the PC Setup settings in the
following way. The settings are default settings for the PC Setup and so if the
baud rate is 9,600 bps, there is no need to make any changes to the default set-
tings.
Item
Baud rate Set to the same baud rate as the NT30/NT30C (See note 1.)
Stop bit 2 stop bits
Parity Even
Data length ASCII 7 bits
Unit # 00
Set SW1 to OFF.
Set SW2 to ON.
Set SW1 to OFF.
Set SW2 to OFF.
CPM1
-CIF01
CPM1
Contents of Settings at Host
Section 2-5
37