Resume Function - Omron NT30 Operation Manual

System Settings
Caution
Correct use

3-8-4 Resume Function

96
[ MAINTENANCE MENU ]
Quit
Display History
I/O Check
PT Settings
Init. Memory
< MEMORY SWITCH >
Key Press Sound
Buzzer Sound
Screen Saver
Resume Memory Table
Printer
To set and quit the menu, press the Quit touch switch. The setting made last will
be set and the display will return to the Maintenance Menu.
• None: The screen OFF function is not used. As long as no operation is per-
formed, the same screen remains to be displayed.
• 10min: The screen will be turned OFF when no operation has been per-
formed for 10 minutes.
• 1hour: The backlight or the EL screen will be turned OFF when no operation
has been performed for 1 hour.
Do not press touch switches carelessly while the backlight is OFF or while noth-
ing is displayed on the screen. Otherwise the system may operate unpredict-
ably.
Only press touch switches after confirming system safety.
After images may remain if the same pattern is displayed for a long period
(approx. 1 hour).
To prevent the formation of an afterimage, either use the screen saver function
or periodically switch screens.
The NT30/30C has a function to protect the contents of the memory tables (value
setting key input, data from the PC, etc.) from being erased even if the power to
the NT30/30C is shut OFF during operation. This function is called the resume
function. Setting the resume function protects the memory tables from being ini-
tialized even when the power is turned ON or reset or when the mode is switched
to the RUN mode by the System Menu operation.
The screen displayed before the power is turned OFF will be displayed again
when the NT30/30C is started next time.
If the memory tables are selected in the Initialize Memory Menu from the Mainte-
nance Mode Menu, the memory tables will be initialized regardless of whether or
Select "Memory Switch."
Memory Switch
Each time the Screen Saver
Next Quit
touch switch is pressed, the
setting
ON
among 10 min, 1 hour, and
ON
None.
10min
None
ESC/P MONO.
Section 3-8
option will switch