Before Operating - Omron NT631 Series Reference Manual

Before Operating

1-6

Before Operating

Downloaded from Elcodis.com electronic components distributor
Follow the procedure given below to start the system of the NT31/NT31C or
NT631/NT631C.
Host
Set the host settings.
Connect to the
NT31/NT31C or
NT631/NT631C.
Create the host program.
Start operation.
*1: System program installation is only done in special circumstances, for example
when changing the system program, or to recover the original status of the
installed program. This operation is not normally necessary. When using other PC
models (sequencers), however, it is necessary to install specific system programs.
*2: Display of the system menu, and all change operations, can be disabled to prevent
the accidental deletion or alteration of screens and settings.
S For the system program, use the NT31/NT31C or NT631/NT631C system
Reference:
program supplied as an accessory with the NT series Support Tool (NT-
ZJCAT1-EV4).
S For the Support Tool, use NT-series Support Tool for Windows 95/98 (Ver. 4.1).
Refer to the following manuals for the Units and software.
NT31/NT31C or
NT631/NT631C
Install the PT in the
operation panel.
Connect the power supply.
*1
Install the system program.
Make the settings in the
*2
system installer mode.
Transmit the screen data.
Set the memory switches.
Connect to the host.
Confirm the settings and
check communication.
Section
Support Tool
Install the Support
Tool at the computer.
(refer to the manual for
the Support Tool)
Create the screens.
(refer to Sections
2through 5 and the
Support Tool manual)
1-6
31