Table of Contents
Advertisement
System cabling
...................................................................................................................................................................................................................................
Cable data
Preferably shielded twisted pair cables (CAT5) should be used (100 Ω symmetrical).
SHDSL interfaces (X12SHDSL-V2 card)
Purpose
The 1645 AMC unit can act as an SHDSL LTU when it is equipped with the
X12SHDSL-V2 option card. SHDSL tributaries can be connected to these interfaces.
Connector data
The SHDSL connectors which are located on the X12SHDSL-V2 option card are RJ45
connectors.
Figure 4-25 SHDSL connector
1
Table 4-13
Cable data
Standard telephony cables can be used (see table below).
Be aware of the following two cases:
• If the cables are going to a distribution frame, an appropriate breakout cable can be
used (e.g. 16 × 2).
• If the cables are connected directly to modems, 2 × 2 cables can be used where only
one pair is required.
...................................................................................................................................................................................................................................
365-313-103R8.0
Issue 2 July 2009
8
Pin assignment (SHDSL cables)
Point on connector
1
2
3
4
5
6
7
8
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
Option card cable installation
DS1 interfaces (Main board/X16DS1 card)
Signal name
nc
nc
nc
Tip [UKS1/a]
Ring [UKS1/b]
nc
nc
nc
4-25
Advertisement
Chapters
Table of Contents
