Table of Contents
Advertisement
ITM-CIT installation and NE provisioning
...................................................................................................................................................................................................................................
Result:
E
N D
O F
...................................................................................................................................................................................................
Parameters
NE type
The E type is indicated.
NE name
The E's name is listed. The name must be unique across management domains. If the
E is not managed by the OMS, then the name may be up to 20 characters in length. If
the E will be managed by the OMS, then the name must be 3 to 10 characters long with
the last three characters a slash and two digits.
NE location
The location of the E is given. The location may have up to 20 uppercase or lowercase
characters, digits, and spaces.
MIB state
The status of the MIB is indicated. The possible values are described in the table below:
MIB state
Empty
Filled
Filled Unknown
Filled ot Confirmed
Waiting for Upload
Management state
...................................................................................................................................................................................................................................
365-313-103R8.0
Issue 2 July 2009
The ode Details window disappears.
S T E P S
Description
An empty System Controller (SC) has been inserted or the MIB was
cleared after starting an MIB download automatically by the
management system. If the MIB state is empty, the management
system can proceed with the MIB download.
The E possesses a valid MIB which has been confirmed.
The E has a MIB, however, it is of unknown validity. This can occur,
for instance, if one SC is replaced by another SC having a MIB.
The E has a MIB, however, it has not yet been confirmed by the
ITM-CIT or OMS. The procedure
(p. 6-22)
confirmed, the state will become Filled.
This state is only possible when the E is managed by the OMS. After
confirmation of the MIB, the E performs a reset and loses its
association with the OMS. When the E restarts, the MIB state
becomes Waiting for Upload. When the OMS reassociates with the E
and detects this MIB state, a MIB upload is performed, and the state
will then become Filled.
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
gives the steps necessary to confirm the MIB. Once
Provisioning system parameters
Confirm/Update the MIB
"Confirm/Update the MIB"
6-23
Advertisement
Chapters
Table of Contents
