Table of Contents
Advertisement
Stand-alone test procedures
...................................................................................................................................................................................................................................
X8PL and X5IP option card test
Overview
This test verifies that the Ethernet option card under test is properly installed and that it
functions correctly. In case of a DDF, the connections are tested by generating a port
alarm. This procedure applies to X8PL and X5IP Ethernet option cards.
Estimated duration
10 minutes
Start condition
Make sure the following start conditions are fulfilled:
• The procedure in section
been performed and the test results are correct.
• The ITM-CIT must be connected and logged-in to the E.
• Ethernet Ports in Auto egotiation Mode:
Procedure
Proceed as follows to perform the X8PL and X5IP option card test:
...................................................................................................................................................................................................
1
Assign the installed option card.
...................................................................................................................................................................................................
Set the alarm LA c ES (LA
2
...................................................................................................................................................................................................
3
Connect LA 2.1 to LA 2.2 using CAT5 crossed UTP Ethernet cables.
...................................................................................................................................................................................................
Check on the alarm list, and verify that the requirements mentioned in the table below are
4
met.
Result:
LEDs on the 1645 AMC :
Power LED:
Fault LED:
Link LEDs of related LA ports:
Alarms reported on the ITM-CIT:
...................................................................................................................................................................................................................................
7-18
"Preparation and test of the main unit" (p. 7-4)
ot Expected Input Signal) to "
Requirements
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
X8PL and X5IP option card test
Enabled
(Default)
Reported
On
Off
On (green)
"LA c ES" reported on LA 2.1 and
LA 2.2
must have
".
365-313-103R8.0
Issue 2 July 2009
Advertisement
Chapters
Table of Contents
