Table of Contents
Advertisement
General information
...................................................................................................................................................................................................................................
• Work in an area which is protected against electrostatic discharge. Use conducting
floor and bench mats which are conductively connected to an ESP bonding point.
• Conductively connect all test equipment and trolleys to an ESP bonding point.
• Store and ship the option cards/SFPs in their shipping packing. The option cards/SFPs
must be packed and unpacked only at workplaces suitably protected against build-up
of charge.
• Whenever possible, maintain the relative humidity of air above 20%.
ITM-CIT requirements
Requirements
For the ITM-CIT a personal computer is necessary which fulfils the following minimum
requirements:
• Pentium
• 128 MB RAM or higher
• Keyboard
• Mouse
• 300 MB of free hard-disk drive space
• CD-ROM drive
• Display with 1024 × 768, 16 million colors recommended
• RS-232 communication port (serial asynchronous port)
• Microsoft
• ITM-CIT connector (F-interface) cable (one end RS-232 and the other end RJ-45
modular jack), CC848069795.
The performance can be enhanced by using a higher performance personal computer.
Independent of the requirements listed above the minimum requirements of the operating
system must be fulfilled. A CD-ROM containing the ITM-CIT software must be
available.
...................................................................................................................................................................................................................................
2-10
®
processor with 450 MHz or higher
®
®
Windows
2000 or Windows XP
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
®
operating system
EMC/ESD information
365-313-103R8.0
Issue 2 July 2009
Advertisement
Chapters
Table of Contents
