Table of Contents
Advertisement
Stand-alone test procedures
...................................................................................................................................................................................................................................
Conclusion: If the Fault LED is OFF, then the option card is accepted and the option
card software is correctly loaded. If the Link LED comes on and the alarms are
reported, then the option card is correctly installed.
...................................................................................................................................................................................................
5
If a DDF is applicable, then proceed with
with
Step
...................................................................................................................................................................................................
6
Connect LA 2.1 to LA 2.3.
...................................................................................................................................................................................................
Check on the alarm list, and verify that the requirements mentioned in the table below are
7
met.
Result:
Link LEDs of related LA ports:
Alarms reported on the ITM-CIT:
Conclusion: Results of
LA 2.2, and LA 2.3 is correct.
...................................................................................................................................................................................................
Connect LA 2.1 to the next LA port.
8
...................................................................................................................................................................................................
9
Check on the alarm list, and verify that the requirements mentioned in the table below are
met.
Result:
Link LEDs of related LA ports:
Alarms reported on the ITM-CIT:
...................................................................................................................................................................................................
Repeat
10
...................................................................................................................................................................................................
11
Disconnect the LA cable from the LA ports. Wait until all LA c ES alarms have
cleared.
...................................................................................................................................................................................................
12
Insert a GbE SFP in the SFP slot of the X5IP.
...................................................................................................................................................................................................................................
365-313-103R8.0
Issue 2 July 2009
11.
Step 4
Step 8
and
Step 9
for all other LA ports.
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
Step
6. If no DDF is applicable, then proceed
Requirements
On (green)
"LA c ES" reported on LA 2.1 and
LA 2.3
and
Step 7
prove that the DDF labeling of LA 2.1,
Requirements
On (green)
"LA c ES" reported on related LA
X8PL and X5IP option card test
7-19
Advertisement
Chapters
Table of Contents
