Table of Contents
Advertisement
About this document
...................................................................................................................................................................................................................................
• Chapter 4, System cabling
This chapter provides all tasks for a complete system cabling.
• Chapter 5, Powering
This chapter describes the system powering and some final tests which should be
performed to end the physical installation part.
Part II – NE provisioning and stand alone installation test
• Chapter 6, ITM-CIT installation and E provisioning
This chapter describes the ITM-CIT and E software installation and the initial E
provisioning via ITM-CIT.
• Chapter 7, Stand alone test procedures
This chapter provides all tests which must be performed to verify the proper working
of the units/ Es.
Part III – Link testing
• Chapter 8, Link testing
This chapter provides link acceptance tests which are necessary to verify the
functionality of the overall system.
• Chapter 9, Conclusion
This chapter provides a final checklist and a signoff sheet to be sure that all required
tasks described in this manual have been done.
Appendices
• Appendix A, Mounting rules
This chapter provides rules which have to be observed during physical installation.
• Appendix B, Installation Troubleshooting
This chapter provides basic installation troubleshooting information.
• Appendix C, Cable assembly instructions
This chapter provides general cable assembly instructions.
Glossary provides definitions for telecommunication acronyms and terms.
Index supplies users with specific subjects and corresponding page numbers to find
necessary information.
Conventions used
The following conventions are used throughout the manual:
Numbering
The chapters of this document are numbered consecutively. The page numbering restarts
at "1" in each chapter. To facilitate identifying pages in different chapters, the page
numbers are prefixed with the chapter number. For example, page 2-3 is the third page in
chapter 2.
Cross-references
Cross-reference conventions are identical with those used for numbering, i.e. the first
number in a reference to a particular page refers to the corresponding chapter.
...................................................................................................................................................................................................................................
xvi
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
365-313-103R8.0
Issue 2 July 2009
Advertisement
Chapters
Table of Contents
