...................................................................................................................................................................................................................................

Result:

LEDs on the 1645 AMC :

Power:

Fault:

PDH analyzer:

Alarms reported on the ITM-CIT:

Notes:

...................................................................................................................................................................................................

Check if the slot and port number of the ES alarm source corresponds with the physical

position on the DDF to which the analyzer is connected.

...................................................................................................................................................................................................

Disconnect the incoming signal from the port under test.

...................................................................................................................................................................................................

Repeat this test for all present option card tributary ports.

N D

O F

...................................................................................................................................................................................................

Cleaning up

The following tasks must be performed to clean up the system:

• Reset the Alarm Reporting/Severity of the applicable ES alarm to default ( ot

Reported).

• If an X3E3DS3 option board is installed and the TUG structure of CC1,1 has been

modified, then return it to VC-12.

• Delete all cross-connections

7-14

ot Expected Input Signal alarm refer to

S T E P S

Proprietary – Use pursuant to Company instruction

Requirement