Table of Contents
Advertisement
8 Web Page Reference
8.3.4.3
Wireless Configuration
Step 2 of the installation wizard requires the installer to enter the wireless configuration
parameters.
Figure 46 –PTP 58500 and PTP 54500 Variants -
Installation Wizard Wireless Configuration
Target MAC Address: It is the MAC Address of the peer unit that will be at the other end of
the wireless link. This is used by the system to ensure the unit establishes a wireless link to
the correct peer.
The MAC Address can be found embedded within the serial number of the unit. The last six
characters of the serial number are the last three bytes of the unit's MAC address.
NOTE: A PTP 500 Series system is shipped as a pair of units with pre-loaded correct MAC
addresses. Target MAC addresses will only need to be entered if an existing unit has to be
replaced in the field or the units configuration has been erased.
108
Advertisement
Table of Contents
