Table of Contents
Advertisement
While the majority of the system configuration is entered during installation and should never
require changing, this page offers the system administrator the ability to change the basic
system parameters for both the wireless and Ethernet components.
Link Name: User defined identity for the unit (max 63 characters).
Link Location: Can be used as a generic scratch pad to describe the location of the
equipment.
Master Slave Mode and Link Mode Optimization: Current settings are displayed and can
be modified using the Installation Wizard pages 8.3.4 "Install Pages".
Max Receive Modulation Mode: This is the maximum mode the unit will use as its adaptive
modulation. By default the Max Receive Modulation Mode is the highest mode available.
Maximum Transmit Power: This specifies the maximum transmit power in dBm of the
system. It is country dependent and although the user can change this in 1dB steps, it will be
limited to that country's regulations
NOTE: Why Reduce Transmit Power? If the link losses are low and the link data rate and
availability targets are being easily achieved, the transmitted power level may be reduced
with a consequent benefit to other users of the band, such as fixed satellite links.
11
In the UK there is a legal requirement to provide a minimum of 19dB of transmit power control range. When
the equipment is operating with a UK Licence Key, an additional facility is provided on the configuration page that
allows the transmitted power to be reduced by 19dB compared to the maximum allowed with a simple single step
control.
11
.
88
8 Web Page Reference
Advertisement
Table of Contents
