Table of Contents
Advertisement
8 Web Page Reference
Ethernet Tx Packets: This displays the total number of good packets the bridge has sent for
transmission by the local Ethernet interface. See footnote 14.
Ethernet Rx Packets: This displays the total number of good packets the bridge has
received from the local Ethernet interface. See footnote 14.
Packets To Internal Stack: This displays the total number of good packets the bridge has
transmitted to the internal stack (for example, ARP requests, PING requests, HTTP requests).
See footnote 14.
Packets From Internal Stack: This displays the total number of good packets the bridge has
received from the internal stack (for example ARP responses, PING replies, HTTP
responses). See footnote 14.
Transmit Data Rate: The data rate in the transmit direction, expressed in Mbps and
presented as: max, mean, min, and latest in an histogram format. The max, min and latest
are true instantaneous measurements; the mean is the mean of a set of one second means.
See footnote 8. Expected data rates can be found in Section 14 "Data Rate Calculations".
Receive Data Rate: The data rate in the receive direction, expressed in Mbps and presented
as: max, mean, min, and latest in an histogram format. The max, min and latest are true
instantaneous measurements; the mean is the mean of a set of one second means. See
footnote 8. Expected data rates can be found in Section 14 "Data Rate Calculations".
Aggregate Data Rate: The sum of the data rate in the directions expressed in Mbps and
presented as: max, mean, min, and latest in an histogram format. The max, min and latest
are true instantaneous measurements; the mean is the mean of a set of one second means.
See footnote 8. Expected data rates can be found in Section 14 "Data Rate Calculations".
Link Capacity: The maximum aggregate data capacity available for user traffic under the
current radio link conditions, assuming the units have been connected using Gigabit Ethernet.
The sum of the displayed Transmit and Receive data rates may be lower than this figure if the
link isn't fully loaded by the current traffic profile.
Transmit Modulation Mode: The modulation mode currently being used on the transmit
channel. The number in brackets after the modulation mode and coding rate string is the
effective data rate available to all MAC layer protocols. List of all the modulation modes can
be found in Section 14 "Data Rate Calculations" where data rate calculations plots are given
for each available modulation mode.
100
Advertisement
Table of Contents
