Table of Contents
Advertisement
See footnote 8. Expected data rates can be found in Section 14 "Data Rate Calculations".
Link Capacity: The maximum aggregate data rate capacity available for user traffic,
assuming the units have been connected using Gigabit Ethernet. The link capacity is variable
and depends of the prevailing wireless conditions as well as the distance (range) between the
two wireless units.
Transmit Modulation Mode: The modulation mode currently being used on the transmit
channel. List of all the modulation modes can be found in Section 14 "Data Rate Calculations"
where data rate calculations plots are given for each available modulation mode.
Receive Modulation Mode: The modulation mode currently being used on the receive
channel. List of all the modulation modes can be found in Section 14 "Data Rate Calculations"
where data rate calculations plots are given for each available modulation mode.
Receive Modulation Mode Detail: This supplies the user with information regarding the
receive modulation mode in use. Possible values are:
•
Running at maximum receive mode
•
Running at user-configured Max Modulation Mode
•
Restricted due to byte errors on the wireless link or local Ethernet Tx Fifo Drops
•
Restricted because a DFS channel change is in progress
•
Restricted due to telecoms acquisition mode
•
Restricted due to the low Ethernet link speed
•
Limited by the wireless conditions
Range: The range
the PTP 500 Series during installation.
10
The PTP 500 Series Bridge displays range in km by default, if the user would prefer to display range using
Miles the 'Distance Units' attribute should be set to imperial, see the "
10
between the 500 Series bridge ODUs. The range is automatically set by
85
8 Web Page Reference
Properties
" web page Section 8.3.14.
Advertisement
Table of Contents
