16
MOD functions
16.5 Software numbers
16.5
Software numbers
Application
The following software numbers are displayed on the TNC screen
after the "Software version" MOD function has been selected:
Control model: Designation of the control (managed by
HEIDENHAIN)
NC
software: Number of the NC software (managed by
HEIDENHAIN)
NCK: Number of the NC software (managed by
HEIDENHAIN)
PLC
software: Number or name of the PLC software
(managed by your machine tool builder)
In the "FCL information" MOD function, the TNC shows the
following information:
Development level (FCL=Feature Content Level):
Development level of the software installed on the control, See
"Feature Content Level (upgrade functions)", page 11
16.6
Entering the code number
Application
The TNC requires a code number for the following functions:
Function
Selecting user parameters
Configuring an Ethernet card
Enabling special functions for Q parameter
programming
496
Code number
123
NET123
555343
HEIDENHAIN Conversational Programming | 5/2013
TNC 620 | User's Manual