Optional Program-Run Interruption - HEIDENHAIN TNC 620 User Manual

15
Test run and program run

15.8 Optional program-run interruption

15.8 Optional program-run interruption
Application
The TNC optionally interrupts program run at blocks containing M1.
If you use M1 in the Program Run mode, the TNC does not switch
off the spindle or coolant.
Do not interrupt program run or test run at blocks
containing M1: Set soft key to OFF
Interrupt program run or test run at blocks
containing M1: Set soft key to ON
490
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013