HEIDENHAIN TNC 620 User Manual page 76

2
Introduction
2.4 Status displays
Program section repeat/Subprograms (LBL tab)
Soft key Meaning
No direct Active program section repeats with block
selection number, label number, and number of
possible programmed repeats/repeats yet to be run
Active subprogram numbers with block number
in which the subprogram was called and the
label number that was called
Information on standard cycles (CYC tab)
Soft key Meaning
No direct Active machining cycle
selection
possible
Active values of Cycle 32 Tolerance
76
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013