Labeling Subprograms And Program Section Repeats - HEIDENHAIN TNC 620 User Manual

7
Programming: Subprograms and program section repeats
7.1

Labeling Subprograms and Program Section Repeats

7.1 Labeling Subprograms and Program
Section Repeats
Subprograms and program section repeats enable you to program a
machining sequence once and then run it as often as necessary.
Label
The beginnings of subprograms and program section repeats are
marked in a part program by labels (LBL).
A LABEL is identified by a number between 1 and 999 or by a
name you define. Each LABEL number or LABEL name can be set
only once in the program with the LABEL SET. The number of label
names you can enter is only limited by the internal memory.
Do not use a label number or label name more than
once!
Label 0 (LBL 0) is used exclusively to mark the end of a
subprogram and can therefore be used as often as desired.
224
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013