Using 3-D Touch Probes (Touch Probe Function Software Option) - HEIDENHAIN TNC 620 User Manual

Using 3-D touch probes (Touch Probe Function software option) 13.5

13.5 Using 3-D touch probes (Touch Probe
Function software option)
Overview
The following touch probe cycles are available in the Manual
Operation mode:
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.
The TNC must be specially prepared by the machine
tool builder for the use of a 3-D touch probe. Refer to
your machine manual.
Function
Calibrating the effective length
Calibrating the effective radius
Measuring a basic rotation using a
line
Setting a datum in any axis
Setting a corner as datum
Setting a circle center as datum
Setting the centerline as datum
Touch probe system data
management
For more information about the touch probe table,
refer to the User's Manual for Cycle Programming.
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013
Soft key Page
435
436
440
442
443
445
447
See User's
Manual for
Cycles
13
427