HEIDENHAIN TNC 620 User Manual page 13

Modified functions 34056x-04
The maximum number of characters for the NAME and DOC fields
in the tool table has been increased from 16 to 32 (Enter tool data
into the table, page 148).
The columns ACC were added to the tool table (Enter tool data into
the table, page 148).
Operation and position behavior of the manual probing cycles has
been improved (Using 3-D touch probes (Touch Probe Function
software option), page 427).
Predefined values can now be entered into a cycle parameter
with the PREDEF function in cycles (see User's Manual for Cycle
Programming).
A new optimization algorithm is now used with the KinematicsOpt
cycles (see User's Manual for Cycle Programming).
With Cycle 257 , circular stud milling, a parameter is now available
with which you can determine the approach position on the stud
(see User's Manual for Cycle Programming)
With Cycle 256, rectangular stud, a parameter is now available with
which you can determine the approach position on the stud (see
User's Manual for Cycle Programming).
With the "Basic Rotation" probing cycle, workpiece misalignment
can now be compensated for via a table rotation (Compensation of
workpiece misalignment by rotating the table, page 440)
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013
TNC model, software and features
13