HEIDENHAIN TNC 620 User Manual page 552

17
Tables and overviews
17.5 Functions of the TNC 620 and the iTNC 530 compared
M Effect
M114 Automatic compensation of machine geometry when working
with tilted axes
M115 Reset M114
M116 Feed rate on rotary tables in mm/min
M117 Reset M116
M118 Superimpose handwheel positioning during program run
M120 Pre-calculate the radius-compensated contour (LOOK AHEAD)
M124 Contour filter
M126 Shorter-path traverse of rotary axes:
Reset M126
M127
M128 Maintaining the position of the tool tip when positioning with
tilted axes (TCPM)
M129 Reset M128
M130 Within the positioning block: Points are referenced to the
untilted coordinate system
M134 Exact stop at nontangential contour transitions when
positioning with rotary axes
M135 Reset M134
M136 Feed rate F in millimeters per spindle revolution
M137 Reset M136
M138 Selection of tilted axes
M140 Retraction from the contour in the tool-axis direction
M141 Suppress touch probe monitoring
M142 Delete modal program information
M143 Delete basic rotation
M144 Compensating the machine's kinematic configuration for
ACTUAL/NOMINAL positions at end of block
M145 Reset M144
M148 Automatically retract tool from the contour at an NC stop
M149 Reset M148
M150 Suppress limit switch message
M197 Rounding the corners
M200 Laser cutting functions
-M204
552
TNC 620
–
(recommended:
M128, TCPM)
X, option #08
X, option 21
X, option 21
– (possible
via user
parameters)
X
X, option #09
X
–
X
X
X
X
–
X
X, option #09
X
– (possible via
FN 17)
X
–
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013
iTNC 530
X, option #08
X, option #08
X
X
X
X
X, option #09
X
X
X
X
X
X
X
X
X, option #09
X
X
–
X