HEIDENHAIN TNC 620 User Manual page 158

5
Programming: Tools
5.2 Tool data
Selecting a pocket table in the Programming mode of operation
Call the file manager
Display the file types: Press the SHOW ALL soft
key
Select a file or enter a new file name. Conclude
your entry with the ENT key or the SELECT soft
key
Abbr.
P
T
RSV
ST
F
L
DOC
PLC
P1 ... P5
PTYP
LOCKED_ABOVE
LOCKED_BELOW
LOCKED_LEFT
LOCKED_RIGHT
158
Inputs
Pocket number of the tool in the tool magazine
Tool number
Pocket reservation for box magazines
Special tool ( ST); If your special tool blocks pockets in front of
and behind its actual pocket, these additional pockets need to
be locked in column L (status L).
The tool is always returned to the same pocket in the tool
magazine
Locked pocket (see also column ST)
Display of the comment to the tool from TOOL.T
Information on this tool pocket that is to be sent to the PLC
Function is defined by the machine tool builder. The machine
tool documentation provides further information
Tool type. Function is defined by the machine tool builder. The
machine tool documentation provides further information
Box magazine: Lock the pocket above
Box magazine: Lock the pocket below
Box magazine: Lock the pocket at left
Box magazine: Lock the pocket at right
Dialog
-
Tool number?
Pocket reserv.: Yes
= ENT / No = NOENT
Special tool?
Fixed pocket? Yes =
ENT / No = NO ENT
Pocket locked Yes =
ENT / No = NO ENT
-
PLC status?
Value?
Tool type for pocket
table?
Lock the pocket
above?
Lock the pocket
below?
Lock the pocket at
left?
Lock the pocket at
right?
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013