WEC8050 / WEC8500 Operation Manual
Configuration using CLI
Execute the following commands to configure the AP access account.
1) Go to configure APC mode of CLI.
WEC8500# configure terminal
WEC8500/configure# apc
WEC8500/configure/apc #
2) Add an AP CLI account.
ap-account [ID] [PASSWORD] [LEVEL]
Parameter
ID
Password
Level
3) An account can be deleted by entering the 'no' parameter as shown below.
no ap-account [ID]
4) Use the 'show apc ap-account' command to retrieve the AP configuration information.
Configuration using Web UI
In the menu bar of <WEC Main Window>, select <Configuration>, and then select
<Local Management Users> AP in the submenu.
Click the 'Add' or 'Delete' button to add or delete the AP CLI account.
© Samsung Electronics America
This is the ID of the AP CLI account.
Only an alphanumeric value of up to eight characters can be entered.
This is the password of the AP CLI account.
Only an alphanumeric value of up to eight characters can be entered.
This is the level of the AP CLI account.
Available values are administrator/operator/monitor.
Figure 93. AP CLI Account Add/Remove Window
Description
Version 7.1
page 198 of 673