Samsung WEC8500 Operation Manual page 288

WEC8050 / WEC8500 Operation Manual
6.4 Country Code
You can use a country code to restrict the number of channels that can be used in an AP and
the maximum transmission power of each channel.
Configuration using CLI
To configure the country code function, go to country mode first by executing the
following command.
APC# configure terminal
APC/configure# country
APC/configure/country#
[Global Country Code Configuration]
If you configure a global country code, the country code can be specified to all the
connected APs at the same time. The command is shown below.

set-global [COUNTRY_CODE] [VALUE]
Parameter
COUNTRY_CODE
VALUE
To check the configuration information, use the 'show country global-config' command.
[AP Country Code Configuration]
To configure a country code, execute the command as follows:

set-ap [AP_ID] [COUNTRY_CODE] [VALUE]
Parameter
AP_ID
COUNTRY_CODE
VALUE
To check the configuration information, use the 'show country ap-config [AP_ID]'
command.
[AP Group Country Code Configuration]
To configure a country code, execute the command as follows:

set-group [AP group ID] [COUNTRY_CODE] [VALUE]
© Samsung Electronics America
Description
Country code to configure
Environment configuration (both/outdoor/indoor/none)
Description
AP ID (range: 1-500)
Country code to configure
Environment configuration (both/outdoor/indoor/none)
Version 7.1
page 288 of 673