WEC8050 / WEC8500 Operation Manual
Default-cost configuration
Configure a value between 0 and 1677215 as a default-cost. However, operator can
configure the default-cost value in AREA ID whether a stub or NSSA is configured.
If you try to configure the default-cost in an ID where neither the two items are configured,
the following error phrase is displayed.
'% The area is neither stub, nor NSSA'
WEC8500/configure/router/ospf 2# area 0.0.0.1 default-cost ?
0 - 16777215
WEC8500/configure/router/ospf 2# area 0.0.0.1 default-cost 3 ?
<cr>
WEC8500/configure/router/ospf 2# area 0.0.0.1 default-cost 3
Shortcut configuration
For Shortcut configuration, operator can select one out of 3 selections including default,
disable, and enable.
WEC8500/configure/router/ospf 2# area 0.0.0.1 shortcut ?
default
disable
enable
WEC8500/configure/router/ospf 2# area 0.0.0.1 shortcut enable
WEC8500/configure/router/ospf 2#
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller> <Network> <OSPF> <Area> <Detail> menu in the sub-
menus.
The configuration page is as follows:
Select a PROCESS ID for detail configuration. As mentioned in the CLI, the Stub or NSSA
must be configured to the PROCESS ID in a window where default-cost is selected. If a
PROCESS ID without the configuration is completed, the detail configuration can not be
performed. Therefore, the below default-cost configuration is available only when the Stub
or NSSA is configured to the ID.
© Samsung Electronics America
Stub's advertised default summary cost
Set default shortcutting behavior
Disable shortcutting through the area
Enable shortcutting through the area
Version 7.1
page 102 of 673