Ap-Group [Ap_Group_Name]; No Ap-Group [Ap_Group_Name] - Samsung WEC8500 Operation Manual

WEC8050 / WEC8500 Operation Manual
4.2.1.1 General AP Group Settings
To aid management of APs in groups, the APC allows configuration of settings which can
be applied commonly to each group. The following functions are provided:
Parameter
Description
AP Mode
Location
IP Mode
AP Status
Redundancy
The APC provides the overwrite option for each AP group setting. If the Overwrite option
is enabled for each setting, the respective setting is applied to all APs within the group.
For example, if the Overwrite option is enabled for AP Mode and AP Mode is set to
General, all the APs within the group will run as General APs.
Configuration using CLI
To configure redundancy settings for the AP group, perform the following commands:
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure#
2) Enter the AP Group configuration mode.


ap-group [AP_GROUP_NAME]

3) Enter the profile configuration mode for the AP group.

Profile
4) Configure the following AP group profiles:

description

overwrite-ap-mode

no overwrite-ap-mode

ap-mode

overwrite-location

no overwrite-location

location
© Samsung Electronics America
Description
This configures the description of the AP group.
This configures the operation mode of the AP. The operator can select
General AP, Root AP, or Repeater AP.
This configures the installation location information of the AP.
This configures the IP configuration mode of the AP. The operator can select
DHCP or AP Priority.
This configures the up/down status of the AP.
If the APCs are configured for redundancy, this configures the discovery
type and Primary/Secondary/Tertiary Controller settings of the AP.
Version 7.1
page 162 of 673