Samsung WEC8500 Operation Manual page 174

WEC8050 / WEC8500 Operation Manual
Parameter
OVERWRITE-
TEMPERATURE-ALARM
TEMPERATURE-ALARM-ON-
LEVEL
TEMPERATURE-ALARM-
OFF-LEVEL
TEMPERATURE-ALARM-
CONTROL-TYPE
OVERWRITE-LINK-
AGGREGATION
LINK-AGGREGATION
5) Use the 'show ap-group detail [AP_GROUP_NAME]' command to check the AP
group information.
Configuring AirMove Service of AP Group with CLI
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure#
2) Create an AP group or enter the AP group configuration mode.

ap-group [AP_GROUP_NAME]
3) Enter the profile configuration mode for the AP group.

profile
4) Configure the AirMove service of the AP group.

enable: Enables/disables the AirMove service.
© Samsung Electronics America
If the overwrite-temperature-alarm is activated, the temperature
alarm information set in the AP group is applied to all APs in the
group.
If the temperature of the AP exceeds the Temperature-Alarm-On-
Level, the temperature alarm occurs.
The default is 98 and possible to set between 50 and 130.
If the temperature of the AP is less than the Temperature-Alarm-
Off-Level, the temperature alarm is cleared.
The default is 90 and possible to set between 50 and 130.
If the temperature alarm occurs, whether the radio of the AP is
set to be off or on.
If the overwrite-link-aggregation is activated, the link aggregation
information set in the AP group is applied to all APs in the group.
In case of an AP model for 802.11ac, provide two uplink Ethernet
ports.
Possible to set link aggregation for two Ethernet ports.
If link aggregation is activated, possible to set the following
mode:
- Both (Destination + Source)
- Destination
- Source
Description
Version 7.1
page 174 of 673