Figure 249. Adding Snmp Community - Samsung WEC8500 Operation Manual

WEC8050 / WEC8500 Operation Manual
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Administrator> and then select the
<SNMP>  <Community> menu in the sub-menus. When you click the <Add> button in
the Community window, the community creation window is displayed. When you enter a
configuration value and click the <Apply> button, the configuration is applied.
10.1.2 SNMP Trap
All the alarms of the APC system are basically transmitted to outside through the SNMP
trap. Therefore, to receive a system alarm from an external management server, the server
address must be registered as a trap target. The trap supports v1/v2.
Configuration using CLI
To add a SNMP trap target, execute the command as follows:
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure#
2) Add a SNMP trap target.

snmp trap [TRAP_VERSION] [COMMUNITY_NAME] [IP_VERSION]
[IP_ADDRESS] [PORT_NUMBER]
Parameter
TRAP_VERSION
COMMUNITY_NAME
IP_VERSION
IP_ADDRESS
PORT_NUMBER
3) To check the added trap target, use the 'show snmp trap' command.
© Samsung Electronics America
Figure 248. Adding SNMP community
Trap version (v1/v2)
Name of a community to be transmitted
IP address type (v4/v6)
IP address to which a trap will be transmitted
Port number to which a trap will be transmitted (default: 162)
Description
page 460 of 673
Version 7.1