Samsung WEC8500 Operation Manual page 63

WEC8050 / WEC8500 Operation Manual
[switchport trunk allowed vlan]
This command configures the mode of switch port to trunk. The 'no' parameter is used to
delete the configuration.

switchport trunk allowed vlan: Configure VLAN to the trunk mode.

switchport trunk allowed vlan all: Configure all the VLANs to the trunk mode.

switchport trunk allowed vlan none: Stops VLAN data transmission/reception.

switchport trunk allowed vlan add [VLAN_ID]: Adds VLAN to the trunk mode.

switchport trunk allowed vlan remove [VLAN_ID]: Removes VLAN with the trunk mode.

no switchport trunk vlan: Removes all the trunk settings.
[show vlan]
This command retrieves VLAN configuration status.

show vlan [VLAN_ID]: Displays specific VLAN information.

show vlan all bridge 1: Displays all the VLAN information.

show vlan brief: Displays all the VLAN information briefly.

show vlan dynamic bridge 1: Displays dynamic VLAN information.

show vlan static bridge 1: Displays static VLAN information.
[Typical configuration procedure]
The typical configuration procedure of VLAN is as follows:
WEC8500# configure terminal
WEC8500/configure# bridge 1 protocol mstp
WEC8500/configure # vlan database
WEC8500/configure/vlan#vlan {2-4094} bridge 1
WEC8500/configure/vlan# exit
WEC8500/configure# interface vlan1.{2-4094}
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller>  <Interfaces> menu in the sub-menus.
For more information about configuration procedure, see '3.2.1 Interface Management'.
© Samsung Electronics America
Version 7.1
page 63 of 673