Samsung WEC8500 Operation Manual page 177

WEC8050 / WEC8500 Operation Manual
number-of-channel
time scanning
number-of-proreq
during one time scanning
scan-time-channel
scanning
scan-time-interleave
scanning start
scan-time-service
STA's scanning
scan-trigger-level
start
target-ap
<cr>
WEC8500/configure/ap-group default/sta-ssl# enable ?
<cr>
WEC8500/configure/ap-group default/sta-ssl# decision-delta ?
1 - 100
WEC8500/configure/ap-group default/sta-ssl# number-of-channel ?
1 - 20
WEC8500/configure/ap-group default/sta-ssl# number-of-proreq ?
1 - 10
WEC8500/configure/ap-group default/sta-ssl# scan-time-channel ?
0 - 100
WEC8500/configure/ap-group default/sta-ssl# scan-time-interleave ?
1000 - 10000
WEC8500/configure/ap-group default/sta-ssl# scan-time-service ?
1 - 1000
WEC8500/configure/ap-group default/sta-ssl# scan-trigger-level ?
-128 - 0
WEC8500/configure/ap-group default/sta-ssl# target-ap ?
all
keep-ap-config
WEC8500/configure/ap-group default/sta-ssl# end
5) To check the AP group information, use the 'show stats-report conf [ap_group_name]'
command.
WEC8500# show sta-ssl group default
SSL Group Configurations
----------------------------
Sta SSL State
Target AP
© Samsung Electronics America
Set the number of channel required during one
Set the number of probe request required
Set time required for one channel
Set interval time required for new
Set time required for STA service during
Set a trigger level for STA's scanning
Set config target ap
Enter the value [dBm]
Enter the number
Enter the number
Enter the time [ms]
Enter the time [ms]
Enter the time [ms]
Enter the trigger level [dBm]
All
Keep ap config
Disable
Keep Ap Config
Version 7.1
page 177 of 673