Cli: Viewing And Configuring Snmp Community Names - HP Switch 2800 Series Management And Configuration Manual

Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
Default
Community and
Settings
Non-Default
Community and
Settings
Trap Receiver
Data (See page
13-18.)
Figure 13-7. Example of the SNMP Community Listing with Two Communities
13-16

CLI: Viewing and Configuring SNMP Community Names

Community Name Commands
show snmp-server [<community-string>]
[no] snmp-server
[community <community-str>]
[host <community-str> <ip-addr>]
[<none | debug | all | not-info | critical>]
[enable traps <authentication>
Listing Community Names and Values. This command lists the data for
currently configured SNMP community names (along with trap receivers and
the setting for authentication traps — see "SNMP Notification and Traps" on
page 13-18).
Syntax: show snmp-server [<community-string>]
This example lists the data for all communities in a switch; that is, both the
default HPswitch "public" community name and another community named
"blue-team"
To list the data for only one community, such as the "public" community, use
the above command with the community name included. For example:
HPswitch# show snmp-server public
Page
13-16
13-17
13-17
13-22
13-23