Configuring BFD basic functions
The BFD basic functions configuration is the basis for configuring BFD for other protocols.
Configuration prerequisites
Before configuring BFD basic functions, complete the following tasks:
Configure the network layer addresses of the interfaces so that adjacent nodes are reachable to
•
each other at the network layer
Configure the routing protocols that support BFD
•
Configuration procedure
To configure BFD basic functions:
To do...
•
Enter system view
•
Specify the mode for
establishing a BFD session
•
Configure the destination port
number for multi-hop BFD
control packets
•
Configure the source IP
address of echo packets
•
Enter interface view
•
Configure the minimum
interval for receiving BFD
echo packets
•
Configure the minimum
interval for transmitting BFD
control packets
Use the command...
system-view
bfd session init-mode { active |
passive }
bfd multi-hop destination-port
port-number
bfd echo-source-ip ip-address
interface interface-type interface-
number
bfd min-echo-receive-interval
value
bfd min-transmit-interval value
158
Remarks
—
Optional
active by default
Optional
4784 by default
Optional
The source IP address should not
be on the same network segment
as any local interface's IP
address; otherwise, a large
number of ICMP redirect packets
may be sent from the peer,
resulting in link congestion
—
Optional
For relevant information, see the
description of the Required Min
Echo RX Interval field in
"BFD
packet
format."
400 milliseconds by default
Optional
For relevant information, see the
description of the Desired Min TX
Interval field in
"BFD packet
format"
400 milliseconds by default