Max-Response-Time (Igmp-Snooping View); Overflow-Replace (Igmp-Snooping View) - HP 3600 v2 Series Command Reference Manual

max-response-time (IGMP-snooping view)

Syntax
max-response-time interval
undo max-response-time
View
IGMP-snooping view
Default level
2: System level
Parameters
interval: Specifies the maximum response delay for IGMP general queries in seconds. The value ranges
from 1 to 25.
Description
Use max-response-time to set the maximum response delay for IGMP general queries globally.
Use undo max-response-time to restore the default.
This command takes effect only in IGMP snooping-enabled VLANs.
Related commands: igmp-snooping max-response-time and igmp-snooping query-interval.
Examples
# Set the maximum response delay for IGMP general queries globally to 5 seconds.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] max-response-time 5

overflow-replace (IGMP-snooping view)

Syntax
overflow-replace [ vlan vlan-list ]
undo overflow-replace [ vlan vlan-list ]
View
IGMP-snooping view
Default level
2: System level
Parameters
vlan vlan-list: Specifies one or multiple VLANs. You can provide up to 10 VLAN lists. For each list, you
can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The value range of a VLAN
ID is 1 to 4094. If you do not specify any VLAN, the command takes effect for all VLANs. If you specify
one or more VLANs, the command takes effect for the specified VLANs only.
34