Display Mld Host Interface - HP 3600 v2 Series Command Reference Manual

Table 69 Command output
Field
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port,
S-Static port, C-Copy port
Subvlan flags: R-Real VLAN,
C-Copy VLAN
Router port unit board
Router port(s)
( 00:01:30 )
IP group address
MAC group address
Attribute
Host port unit board
Host port(s)

display mld host interface

Syntax
display mld host interface interface-type interface-number group ipv6-group-address [ source
ipv6-source-address ] [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
interface-type interface-number: Displays information about the hosts tracked by MLD on the specified
interface. The specified interface can be a Layer 3 Ethernet port, Layer 3 aggregate interface, or Tunnel
interface.
Host port(s):total 1 port(s).
Eth1/0/2
Description
Total number of IPv6 multicast groups.
Total number of IPv6 multicast sources.
Total number of MAC multicast groups.
Port flag:
D—Dynamic port.
S—Static port.
C—Port copied from a (*, G) entry to an (S, G) entry.
Sub-VLAN flag: R stands for real egress sub-VLAN under the current entry,
and C for sub-VLAN copied from a (*, G) entry to an (S, G) entry.
Mask indicating an IRF member switch with a router port residing on it. If no
IRF fabric exists, Mask (0x0000) is displayed.
Number of router ports.
Remaining time of the aging timer for the dynamic member ports or router
ports. On an IRF member switch, to display the remaining life of a
non-aggregation port that does not belong to the Master device, you must
specify the member ID of the IRF member switch by using slot slot-number.
For an aggregation port, you do not need to do this.
Address of an IPv6 multicast group.
Address of a MAC multicast group.
Attribute of an IPv6 multicast group.
Mask indicating an IRF member switch with a member port residing on it. If
no IRF fabric exists, Mask (0x0000) is displayed.
Number of member ports.
315