C-Bsr Holdtime (Ipv6 Pim View); C-Bsr Interval (Ipv6 Pim View) - HP 3600 v2 Series Command Reference Manual
Ip multicast
Hide thumbs
Also See for 3600 v2 Series:
- Command reference manual (510 pages) ,
- Configuration manual (449 pages) ,
- Security configuration manual (398 pages)
Table of Contents
Advertisement
c-bsr holdtime (IPv6 PIM view)
Syntax
c-bsr holdtime interval
undo c-bsr holdtime
View
IPv6 PIM view
Default level
2: System level
Parameters
interval: BS timeout in seconds, in the range of 1 to 2,147,483,647.
Description
Use c-bsr holdtime to configure the BS timeout, namely, the length of time that the C-BSRs wait for a
bootstrap message from the BSR.
Use undo c-bsr holdtime to restore the default.
By default, the BS timeout value is determined by this formula: BS timeout = BS period × 2 + 10.
The default BS period is 60 seconds, so the default BS timeout is 60 × 2 + 10 = 130 (seconds).
Related commands: c-bsr and c-bsr interval.
Examples
# Set the BS timeout to 150 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] c-bsr holdtime 150
c-bsr interval (IPv6 PIM view)
Syntax
c-bsr interval interval
undo c-bsr interval
View
IPv6 PIM view
Default level
2: System level
Parameters
interval: BS period in seconds, with an effective range of 10 to 2,147,483,647.
Description
Use c-bsr interval to configure the BS period, namely, the interval at which the BSR sends bootstrap
messages.
Use undo c-bsr interval to restore the default.
355
Advertisement
Table of Contents
