Fast-Leave (Mld View); Host-Tracking (Mld View) - HP 3600 v2 Series Command Reference Manual

Ip multicast
Hide thumbs Also See for 3600 v2 Series:
Table of Contents

Advertisement

Description
Use dscp to set the DSCP value for MLD messages.
Use undo dscp to restore the default.
The default DSCP value in MLD messages is 48.
Examples
# Set the DSCP value to 63 for MLD messages.
<Sysname> system-view
[Sysname] mld
[Sysname-mld] dscp 63

fast-leave (MLD view)

Syntax
fast-leave [ group-policy acl6-number ]
undo fast-leave
View
MLD view
Default level
2: System level
Parameters
acl6-number: Specifies a basic IPv6 ACL, in the range of 2000 to 2999. If you do not include this
argument in your command, this command takes effect for all IPv6 multicast groups.
Description
Use fast-leave to configure MLD fast-leave processing globally.
Use undo fast-leave to disable MLD fast-leave processing globally.
By
default,
multicast-address-specific queries or multicast-address-and-source-specific queries after receiving an MLD
done message from a host, instead of sending a leave notification directly to the upstream.
When this command is executed in MLD view, this command takes effect only on Layer 3 interfaces
except VLAN interfaces.
Related commands: last-listener-query-interval and mld fast-leave.
Examples
# Enable MLD fast-leave processing globally.
<Sysname> system-view
[Sysname] mld
[Sysname-mld] fast-leave

host-tracking (MLD view)

Syntax
host-tracking
MLD
fast-leave
processing
is
disabled.
That
327
is,
the
MLD
querier
sends

Advertisement

Table of Contents
loading

Table of Contents