Multicast-Vlan Ipv6 - HP 3600 v2 Series Command Reference Manual

Eth1/0/1
Table 61 Command output
Field
subvlan list
port list

multicast-vlan ipv6

Syntax
multicast-vlan ipv6 vlan-id
undo multicast-vlan ipv6 { all | vlan-id }
View
System view
Default level
2: System level
Parameters
vlan-id: Specifies a VLAN by its ID, in the range of 1 to 4094.
all: Specifies all IPv6 multicast VLANs.
Description
Use multicast-vlan ipv6 to configure the specified VLAN as an IPv6 multicast VLAN and enter IPv6
multicast VLAN view.
Use undo multicast-vlan ipv6 to remove the specified VLAN as an IPv6 multicast VLAN.
No VLAN is an IPv6 multicast VLAN by default.
The specified VLAN to be configured as an IPv6 multicast VLAN must exist.
For the HP 3600 v2 EI switches, the IPv6 multicast VLAN feature cannot be enabled on a device with IPv6
multicast routing enabled.
For a sub-VLAN-based IPv6 multicast VLAN, you must enable MLD snooping only in the IPv6 multicast
VLAN. For a port-based IPv6 multicast VLAN, you must enable MLD snooping in both the IPv6 multicast
VLAN and all the user VLANs.
Related commands: mld-snooping enable and multicast ipv6 routing-enable.
Examples
# Enable MLD snooping in VLAN 100. Configure it as an IPv6 multicast VLAN and enter IPv6 multicast
VLAN view.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 100
[Sysname-vlan100] mld-snooping enable
[Sysname-vlan100] quit
[Sysname] multicast-vlan ipv6 100
Eth1/0/2
Description
List of sub-VLANs of the IPv6 multicast VLAN
Port list of the IPv6 multicast VLAN
294