Last-Listener-Query-Interval (Mld-Snooping View); Max-Response-Time (Mld-Snooping View) - HP 3600 v2 Series Command Reference Manual
Ip multicast
Hide thumbs
Also See for 3600 v2 Series:
- Command reference manual (510 pages) ,
- Configuration manual (449 pages) ,
- Security configuration manual (398 pages)
Table of Contents
Advertisement
last-listener-query-interval (MLD-snooping view)
Syntax
last-listener-query-interval interval
undo last-listener-query-interval
View
MLD-snooping view
Default level
2: System level
Parameters
interval: Sets the MLD last-listener query interval in seconds. The value range is 1 to 5.
Description
Use last-listener-query-interval to configure the MLD last-listener query interval globally.
Use undo last-listener-query-interval to restore the default.
By default, the MLD last-listener query interval is 1 second.
The MLD last-listener query interval determines the interval for sending MLD multicast-address-specific
queries and the maximum response delay for MLD multicast-address-specific queries.
This command takes effect only in MLD snooping-enabled VLANs.
Related commands: mld-snooping last-listener-query-interval.
Examples
# Set the MLD last listener query interval to 3 seconds globally.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] last-listener-query-interval 3
max-response-time (MLD-snooping view)
Syntax
max-response-time interval
undo max-response-time
View
MLD-snooping view
Default level
2: System level
Parameters
interval: Specifies the maximum response delay for MLD general queries in seconds. The value ranges
from 1 to 25.
Description
Use max-response-time to configure the maximum response time for MLD general queries globally.
262
Advertisement
Table of Contents
